[WheelCommander] Wheel Commander problems

["Charley Webb" <charleyshf@xxxxxxxxxxx>]

Hello,

I am using a Basic Stamp module hooked to the Wheel Commander for RX and TX
data, the problem is that I can send data to the WC, I can also send the
calibrate command to the WC (K), and that works, I can also set the baud
rate on the WC, HOWEVER I cannot receive ANYTHING from the WC, it's as if
there is nothing coming out from the TX on the WC.

 

I have also tried to reset the WC which changes nothing, so the same problem
remains, I cannot receive any data from the WC at all. 

 

I have also tried the example code on the Nubotics website, however I get
the same result.

 

Is there something I am missing??